Ducati Diagnostic 4 Pin to OBD2 Adapter

£12.99
+
Brand
BMDiag

Ducati Diagnostic 4 pin DDA OBD2 Adapter Cable

  • Suitable for later Ducati models fitted with the Yellow 4 pin Diagnostic socket
  • Use with our ELM327 interface or your own ELM with Software MelcoDiag, MC39, Etc
  • Free UK shipping included

Buy the complete hardware kit Tested and guaranteed compatible with the software (ELM327 and Adapter cable) CLICK HERE

Ducati CanBus Diagnostics Adapter Cable - Supports newer Ducati models (~2012+) including Panigale, MultiStrada, HyperMotard, Monster and Daivel!

Note: This is the Adapter cable ONLY. You will need to have a compatible scan tool to communicate with the bike. Buy our Interface and adapter cable HERE

4 Pin to OBDII adapter cable for use with ELM based Interfaces and OBD2 scan tools.

Ducati changed the diagnostics protocol and connector by adding a CanBus system around 2012 when they changed to Siemens/Mitsubishi ECUs. Our standard Blue KKL interface popular on the Magneti and Marelli ECUs would not support these new models.  

The Diagnostic plug on the bike can be hard to find, It is usually tucked away towards the back of the ECU and can be easily missed! see picture below.

Ducati 4 pin Diagnostic socket

On this hypermotard the 4 pin plug was to the rear left of the ECU

The  adapter will connect OBD2 diagnostic scan tools to bikes using the 4 pin diagnostics connector shown here - this will include most 2012 and newer Ducati's (please check your bike prior to purchase, or call us if you need assistance!)
 

Ducati 4 pin DDA diagnostic socket
Here is a picture of the diagnostic socket with the cover attached, this is what you will be looking for

Ducati Marelli ECU IAW 7SM Hypermotard
The MelcoDiag software gives limited coverage (You can read and clear faults) on Marelli ECU IAW S7M fitted to later Hypermotard models